Announcement

Collapse
No announcement yet.

Grip plug for the BP9CC

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Grip plug for the BP9CC

    Browsing around I saw this pic, on this site

    grip-plug-for-bersa-bp9cc-9mm-41062114.jpg
    The plug seems to be 3D printed, has any of you ever seen grip plug for Bersa?
    Have you ever used one on a glock or any other gun?
    Are they worh it?

    #2
    No. For what purpose?
    Think Green.......Recycle Congress

    Certified Armed Infidel

    Right Wing Extremist

    Comment


      #3
      Just fill with black RTV to keep the dirt out. I would clean the cavity, wet a few cotton balls with rtv, then stuff that plug about 0.500" deep in the cavity first. Allow it to set up before filling the remainder of the cavity with rtv. I would use tape on the grip to minimize the mess and get a clean lines. RTV is self leveling.

      In memory of our Founder, Michael T. June 15, 1946 - February 26, 2017.

      Comment


        #4
        Does that hole serve any purpose other than gathering lint?

        I saw them for Glocks with logos
        6ee21530883e2d055c237fef20d5b3f4.jpg

        With a hidden takedown tool and oil reservoir
        SI-G-GPT_1__01196.1534554072.jpg

        and even with room for a hidden extra bullet
        images?q=tbn%3AANd9GcR3V8ro3TLmWvmHEIdjbFqmut0X9xUoQ-y-mA&usqp=CAU.jpg

        Comment

        Working...
        X