Announcement

Collapse
No announcement yet.

simple fix for mil-spec sights

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    simple fix for mil-spec sights

    My 1949 sistema had a point of aim pretty high, about 5 inches at 12 yards.
    it looked like the previous owner had filed the rear sight a little bit.
    I used some epoxy steel and simply added some height to the front sight, I built it a little higher than I needed and then shot and filed,shot and file until they were right, and finished with some 600 sandpaper, you would have to look closely to tell.
    It was also shooting to the left a little and by adhering the new sight a little to the left that was also corrected. It was been a couple of months and they seem to be permanent

    #2
    Re: simple fix for mil-spec sights

    Another job for JB Weld. Two most useful things on earth. JB Weld and Duct Tape
    W.W.MT.D-----WHAT WOULD MICHAEL T DO?
    NRA PATRON LIFE MEMBER

    Comment


      #3
      Re: simple fix for mil-spec sights

      Originally posted by R.Ph. 380 View Post
      Another job for JB Weld. Two most useful things on earth. JB Weld and Duct Tape
      Don't forget WD40.
      jr

      Comment

      Working...
      X